Metrologic Instruments MS770 Manuel d'utilisateur télécharger pdf (Page 7)

Figure 4

Figure 5

Back Plate Installation

With the Metrologic back plate

(Part #45473), position the scanner

in one of two directions. The two

orientation choices are vertical or

horizontal. (Refer to Figure 4). To

use this stand, use the four 6-32 x ½

inch machine screws and four wood

screws to attach the unit to the back

plate and work surface. The maxi-

mum distance the screws should go

into the scanner is a ½ inch.

1. Drill four holes into the work surface that correspond with the holes

indicated by an XY in Figure 5.

2. To fasten the scanner to the back plate:

! For a horizontal mount, align the four holes on the back of the

scanner with the four clearance holes located on the back plate

marked with an X in Figure 5.

! For a vertical mount, align the four holes on the back of the

scanner with the four clearance holes located on the back plate

marked with a Y in Figure 5.

3. Fasten the scanner to the back plate by inserting the four 6-32 x ½ inch

screws into the four holes in the scanner’s case. Fasten the scanner and

back plate to the work surface.

1 2 3 4 5 6 7 8 9 10 11 12 ... 26 27

Pas de commentaire

Metrologic Instruments MS770 Manuel d'utilisateur Page 7