Metrologic Instruments MS9524 Manuel d'utilisateur télécharger pdf (Page 13)

DISCONNECTING THE POWERLINK CABLE

Before removing the cable from the scanner, Metrologic recommends that the

power on the host system is off and the power supply has been disconnected

from the PowerLink cable.

Figure 8.

1. Locate the small ‘pin-hole’ on the top of the unit near the bottom of the

Voyager logo.

2. Bend an ordinary paperclip into the shape shown above.

3. Insert the paperclip (or other small metallic pin) into the small ‘pin-hole’.

4. You will here a faint ‘click’. Pull gently on the strain-relief of the PowerLink

cable and it will slide out of the scanner.

CONNECTING THE POWERLINK CABLE

Important: If the PowerLink cable is not fully 'latched' the unit

can power intermittently.

Figure 9b.Figure 9a.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 55 56

Pas de commentaire

Metrologic Instruments MS9524 Manuel d'utilisateur Page 13